Fácil y rápido de instalar y programar.
El micromódulo es un Marmitek módulo de aparato X-10 muy compacto que puede montarse detrás de interruptores presentes o enchufes murales. La iluminación y los aparatos conectados al micromódulo pueden entonces manejarse por el Marmitek sistema X-10. Al mismo tiempo el interruptor puede emplearse de la manera normal. El micromódulo utiliza la comunicación X-10 unidireccional.
Comercios:
Aquí puede ingresar su código postal para buscar tiendas cercas que venden el producto arriba.
→ Contenido del set
→ Especificaciones técnicas
→ Información para pedir
| No. de art. | |||||||||
| 08055 |
UG AMM31 EN (PDF 0.48 MB)
UG AMM31 DE (PDF 0.55 MB)
UG AMM31 FR (PDF 0.57 MB)
UG AMM31 ES (PDF 0.51 MB)
UG AMM31 IT (PDF 0.56 MB)
UG AMM31 NL (PDF 0.55 MB)
UG AMM32 ES (PDF 0.50 MB)
FCPDL AMM31 (PDF 0.20 MB)
Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.
In connection with heat development, it is not permitted for numerous MicroModules to be used in ONE wall outlet.
This module is a Appliance module.
You can select the Universal Appliance Module (UAM).
Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.
LED lighting can be controlled by all X-10 receivers, except the AM12 (this is equipped with an autosense function. LEDs continue to be slightly illuminated because of the autosense current.) and the LW12, LMM21, LMM22.
LEDs cannot be controlled by the dimmer modules if their total power falls under the minimum load of the relevant module.
Low voltage LEDs (which are controlled via a transformer) and 230V LEDs which often have internal capacitive conversion to low voltage must also be taken into account. These influence the strength of the X-10 signal and can, therefore, cause interruption to the lighting network. In practice, the LED lighting can usually be switched on but cannot be switched off. This can be solved by using an additional FM10 or FD10 module.
The module will retain the same position until it gets a command to change position. If the module was in the ON position, it will return to the ON position after a power failure.
Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.
Is your question still unanswered? Click here for a detailed support request.