Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

To activate the alarm, the so-called HouseCode and address of the alarm system or SM10 need to be set to the same value as that of the PH7208. The standard factory setting is A1.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

The PH7208 uses no extra wires. The system transmits the command to trigger the siren via the mains. These commands are converted to a signal suitable for the mains by Marmitek surveillance systems or a Marmitek SM10 interface. It takes some seconds before the PH7208 responds.

After being triggered, the siren, a piercing two-tone signal, will sound for 4 minutes. After 4 minutes the siren is automatically switched off. When the alarm system is turned off before this time, the PH7208 will also be switched off.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.