AMM32
Two-Load Appliance Micro Module
 "Can we advise you?")
- Switch module to turn 230V appliances, halogen and tube lights, etc. on or off.
- Can be used in combination with ‘designer’ switching material.
- Operation of the unit with Marmitek X-10 Commands takes place via the mains wires, which means no extra wiring is necessary.
- Controllable from a distance with the Marmitek X-10 commands On/Off.
- Makes your X-10 system invisible.
- Transforms your existing switch into a X-10 controllable switch.
- Remote and local control On and Off.
- Can also be used with low-energy lamps.
- Quick and easy to install and program.
- Control Load QTY: Two
The MicroModule is an extremely small Marmitek X-10 appliance module which can be fitted behind any installed switch or outlet. The lights and appliances connected to the MicroModule can be controlled by the Marmitek X-10 system. You will be able to use your switch in the normal way. The MicroModule uses one-way X-10 communication.
 "Click here for more product photos")
FCPDL AMM32 (PDF 0.20 MB)
 "Set includes - AMM32")
UG AMM32 EN (PDF 0.46 MB)
UG AMM32 DE (PDF 0.45 MB)
UG AMM32 FR (PDF 0.46 MB)
UG AMM32 ES (PDF 0.45 MB)
UG AMM32 IT (PDF 0.45 MB)
UG AMM32 NL (PDF 0.45 MB)
 "Technical specifications - AMM32")
In connection with heat development, it is not permitted for numerous MicroModules to be used in ONE wall outlet.
This module is a Appliance module.
You can select the Universal Appliance Module (UAM).
LED lighting can be controlled by all X-10 receivers, except the AM12 (this is equipped with an autosense function. LEDs continue to be slightly illuminated because of the autosense current.) and the LW12, LMM21 and LMM22.
LEDs cannot be controlled by the dimmer modules if their total power falls under the minimum load of the relevant module.
Low voltage LEDs (which are controlled via a transformer) and 230V LEDs which often have internal capacitive conversion to low voltage must also be taken into account. These influence the strength of the X-10 signal and can, therefore, cause interruption to the lighting network. In practice, the LED lighting can usually be switched on but cannot be switched off. This can be solved by using an additional FM10 or FD10 module.
The module will retain the same position until it gets a command to change position. If the module was in the ON position, it will return to the ON position after a power failure.
Is your question still unanswered? Click here for a detailed support request.
| Art.no. | |||||||||
| 08066 | |||||||||
Shops:
Here you can enter your postcode to see which shops sell the product in your local area.
)
)
)
Relevant products for the AMM32
)
The receiver above, you can control with a transmitter
See the complete serie of transmitters here
)
Communication of a wireless transmitter/controller to the dimmers/switch modules goes via a transceiver
See the complete serie of transceivers here
)
)
Found an error on this website? Let us know
© 2012 Marmitek B.V.