Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

Yes, the module has a special connection for momentary switches. These need to be connected to the module by wires. Using more than one momentary switch on one module connection is possible.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

In connection with switch problems, we advise a load of no more than 300W.

Yes. The module is suitable for dimming halogen lighting. The dimmer does not work for every lamp, because not every transformer can be dimmed. Test the combination first, before you fit the transformers. Marmitek X-10 users have indicated that all Osram electronic transformers (Mouse Dimmers/type HTM) and PEHA electronic transformers work well. Wound transformers always have to be of the ‘ring core’ type, not ‘E-core’ type (f.i. Erea). 230 V Halogen lighting normally will work without problems.

LED lighting can be controlled by all X-10 receivers, except the AM12 (this is equipped with an autosense function. LEDs continue to be slightly illuminated because of the autosense current.) and the LW12, LMM21 and LMM22.

LEDs cannot be controlled by the dimmer modules if their total power falls under the minimum load of the relevant module.

Low voltage LEDs (which are controlled via a transformer) and 230V LEDs which often have internal capacitive conversion to low voltage must also be taken into account. These influence the strength of the X-10 signal and can, therefore, cause interruption to the lighting network. In practice, the LED lighting can usually be switched on but cannot be switched off. This can be solved by using an additional FM10 or FD10 module.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

Yes, the module has a special connection for momentary switches. These need to be connected to the module by wires. Using more than one momentary switch on one module connection is possible.