No, the SW10 can be used in place of any normal switch.

The Sun Blind Switch needs to be taught when the blinds are ‘fully open/up’:

• Turn the power on.
• Use the keys to open the blinds all the way (‘fully open/up’).
• Use a screwdriver of coin to set the HouseCode in programming mode (•).
• Use the keys to close the blinds all the way (‘fully closed/down’). Keep the button pressed when the blinds are down, to program an extra closing margin.
• Now set the HouseCode and UnitCode switches to the desired address.

You can now test the switch manually and with the Marmitek X-10 controller (the controller will not work when you have not yet programmed the switch!). The settings are saved in the device, even when there is no power.

No. The module does not respond to these commands.

The module can be combined with switches from the Jung CD500 series, colour Alpine White. If you want to use different switching material, you can use the micromodules.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

The maximum time that can be set is 127 seconds.

Keep pressing the button a little while longer when calibrating the blinds and the blinds are down. Because the load on the motor is bigger when the blinds are opened, it needs a bit more time and it is better to set a longer period for the module.

No. The module does not respond to these commands.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

No, this is a single switch. The line in the middle and the arrows are part of the design.

No. The module does not respond to these commands.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

Keep pressing the button a little while longer when calibrating the blinds and the blinds are down. Because the load on the motor is bigger when the blinds are opened, it needs a bit more time and it is better to set a longer period for the module.