Because the module is fitted with electronics, you not only need to connect the phase (brown) and switch (black) wires to the module, but also the neutral (blue) wire. If you cannot find this wire in the assembly box, you can extend this wire from a wall socket close-by or pull back the blue wire from the load (e.g. the ceiling lamp).

Yes. You can use an module in combination with a momentary switch (any brand). The momentary switch can be connected to the module using existing wiring.

The module can be combined with switches from the Jung CD500 series, colour Alpine White. If you want to use different switching material, you can use the micromodules.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.

No, this is a single switch. The line in the middle and the arrows are part of the design.

In connection with switch problems, we advise a load of no more than 300W.

Yes. The module is suitable for dimming halogen lighting. The dimmer does not work for every lamp, because not every transformer can be dimmed. Test the combination first, before you fit the transformers. Marmitek X-10 users have indicated that all Osram electronic transformers (Mouse Dimmers/type HTM) and PEHA electronic transformers work well. Wound transformers always have to be of the ‘ring core’ type, not ‘E-core’ type (f.i. Erea). 230 V Halogen lighting normally will work without problems.

No, this is a single dimmer. The line in the middle and the arrows are part of the design.

The LW11G contains different software. The LW11G can also activate a soft-start and soft-dim. This means you can increase the dimmer from 0% to the desired setting.

• Is the module connected to the same phase?
• Is the module set to the same HouseCode as the rest of the system?

LED lighting can be controlled by all X-10 receivers, except the AM12 (this is equipped with an autosense function. LEDs continue to be slightly illuminated because of the autosense current.) and the LW12.

LEDs cannot be controlled by the dimmer modules if their total power falls under the minimum load of the relevant module.

Low voltage LEDs (which are controlled via a transformer) and 230V LEDs which often have internal capacitive conversion to low voltage must also be taken into account. These influence the strength of the X-10 signal and can, therefore, cause interruption to the lighting network. In practice, the LED lighting can usually be switched on but cannot be switched off. This can be solved by using an additional FM10 or FD10 module.

Yes, you can use more than one Transceiver in your home when the range of your remotes is not sufficient. The Transceiver is using so called collision detection to prevent signals to be disturbed when more than one Transceiver is transmitting. Transceivers will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the units are placed as far away from each other as possible.