Normally the StereoControl is on standby to save battery power. By pressing a key on your remote within 50 cm of the receiver, you switch on the StereoControl. A red light will flash on the receiver to indicate the device is turned on.
After turning on the StereoControl, it has a sensitivity range of 4-8 m with an opening angle of 30 degrees. This depends on which remote control you use.
The StereoControl does not work with Bang&Olufsen equipment (B&O).
In some cases the receiver can suffer from interference (e.g. direct sunlight, IR alarm, tube lights, energy-saving lamps). In that case you can move the receiver to a place where the reception is better.
Is your question still unanswered? Click here for a detailed support request.