The TMA4 MicroModule is an extremely small Marmitek X10 Transmitter for 4 addresses and the commands ON and OFF. The TMA4 connects up to four maintained switches by wire leads and transmits up to four sequential X-10 powerline carrier ON/OFF addresses. MicroModules use two-way X-10 communication. Marmitek MicroModules are designed to fit in the rear of European junction boxes, behind any installed switch or outlet.
---------------------------------------------------------------------------------------------------------------------
The TMA4 is no longer available. The TWM4 is a good alternative for this.
See the complete serie of transceivers here
Yes, you can use more than one TM13 Transceiver in your home when the range of your remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the TM13 units are placed as far away from each other as possible.
During the programming of the address, a one second pause is needed between both “ON” commands. When these commands are given too quickly one after the other, the address shall not be programmed.
In connection with heat development, it is not permitted for numerous MicroModules to be used in ONE wall outlet.
No, the FD10 only works as a phase coupler for modules which transmit at 0.60 and 120 degrees. You need the CAT4000 for this module. This also strengthens the signal on all phases.
After programming an address, the programming mode needs to be exited. After that, the programming procure needs to be started from the beginning.
Yes, you can use more than one TM13 Transceiver in your home when the range of your remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the TM13 units are placed as far away from each other as possible.
Because the MicroModules are so small, they heat up quicker than the ‘larger’ Marmitek HomeAutomation components. This is not a problem.
Yes, you can use more than one TM13 Transceiver in your home when the range of your remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the TM13 units are placed as far away from each other as possible.
Is your question still unanswered? Click here for a detailed support request.
| Art.no. | |||||||||
| 09301 | |||||||||